Installing your System
BLY1 Wireless Alarm System
13
Getting started...
3. Trigger the next device within 10 seconds to learn it and repeat for additional devices. If the
system has reached its maximum capacity and no more devices ca be added. The control
unit will not beep any more.
4. When you have nished learning the devices, all zone LEDs will turn off after 10 seconds
which indicates successful programming. After this the system returns to standby mode.
Summary of the learn mode LED state
If you have any additional detectors, make sure they are programmed to the control unit
before location testing and installation.
Turn OFF the Main Power Adaptor so that the POWER LED on the Control unit is OFF.
a) Wireless magnetic Door/Window contact (MC) detector
1. Choose where on the door or window you wish to locate
the unit. The transmitter unit is usually mounted on the
frame and should be positioned such that the red LED is
close to the door or window.
2. The magnet should be tted as shown with one narrow
edge level with the at top on the detector housing.
The gap between the magnet and detector should not be
more than 8mm with the arrow on the magnet pointing directly towards the arrow on
the detector.
3. If there is insufcient room to mount the detector on the frame, then it can be
xed to the door or window instead (with the magnet xed to the frame
alongside it.) For reliable operation, the front face of the magnet should be no
more than 8mm from the front face of the detector. In some cases, it may be
necessary to place packing behind the magnet or detector to achieve this.
Fitting
4. Remove and retain the screw from the bottom of the detector. Use a small
drill or screw driver to make two xing holes in the back plate as a template.
Use the backplate to mark and drill two 4mm xing holes 80.5mm apart.
Fix the back plate in position using the screws provided.
5. If you wish add an additional wired magnetic Door/Window contact detector,
then connect the wiring to the two hard wire terminals provided.
Learn mode
state
Learn
Red LED
Z1/Z5
Red LED
Z2/Z6
Red LED
Z3/Z7
Red LED
Z4/Z8
Red LED
Learn
Wireless MC
ON ON ON ON ON
Learn
Wireless PIR
ON FLASH FLASH FLASH FLASH
Learn Wireless
Remote Key
(optional
accessory)
FLASH ON ON ON
Learn
Wireless
External
Siren
FLASH ON
Powering down the control unit
Installing your detectors
Max.
8mm
Frame
52mm
Door / Window
Wireless Alarm System.indd 14 01/06/2012 10:57
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce