Blyss BLY1 Specifikace Strana 13

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 26
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 12
12
Getting started...
Installing your System
BLY1 Wireless Alarm System
2.2 a PIR Detector, trigger the PIR detector by simply moving your hand in
front of the detector.
When a PIR Detector has been learnt successfully, Z5, Z6, Z7 or Z8 zone LED depending on
which next zone is unprogrammed) will ash.
* The use of ear defenders is advisable at this stage*
2.3 a siren, press and release the tamper switch once located on the rear of the siren. The
siren will trigger an alarm. After the control unit conrms the siren is linked (both ‘Learn’
and ‘Z4/Z8’ LEDs will ash together), silence the siren again by moving its power switch
to ‘OFF’ again before installing it on the wall (see diagram on page 10).
2.4 a Remote Control, (Optional Accessory) press and release the disarm button once.
When the device is triggered, the rst available unprogrammed zone LED for that device
will light up on the control unit. The control unit will beep twice to conrm the device has been
learnt and the corresponding zone LED will light up red. (See diagrams below to show which
zone LEDs correspond to which device when learnt). If the device has not been triggered in 10
seconds then re-enter programming mode again (press and hold the “Learn” button for over
5 seconds)
Learn PIR
Learn PIR
Learn remote key
Wireless Alarm System.indd 13 01/06/2012 10:57
Zobrazit stránku 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Komentáře k této Příručce

Žádné komentáře